Armada - Apply Chart

Commands

Usage: armada apply_chart [OPTIONS] [LOCATION]

  This command installs and updates an Armada chart.

  [LOCATION] must be a relative path to Armada Chart or a reference
  to an Armada Chart kubernetes CR which has the same format, except as
  noted in the :ref:`v2 document authoring documentation <document_authoring_v2>`.

  To install or upgrade a chart, run:

          $ armada apply_chart --release-prefix=armada my-chart.yaml
          $ armada apply_chart --release-prefix=armada kube:armadacharts/my-namespace/my-chart

Options:
  --release-prefix TEXT         Release prefix to use.  [required]
  --disable-update-post         Disable post-update Tiller operations.
  --disable-update-pre          Disable pre-update Tiller operations.
  --metrics-output TEXT         Output path for prometheus metric data, should
                                end in .prom. By default, no metric data is
                                output.
  --tiller-host TEXT            Tiller host IP.
  --tiller-port INTEGER         Tiller host port.
  -tn, --tiller-namespace TEXT  Tiller namespace.
  --timeout INTEGER             Specifies time to wait for each chart to fully
                                finish deploying.
  --wait                        Force Tiller to wait until the chart is
                                deployed, rather than using the charts
                                specified wait policy. This is equivalent to
                                sequenced chartgroups.
  --target-chart TEXT           The target chart to deploy. Required for
                                specifying which chart to deploy when multiple
                                are available.
  --bearer-token TEXT           User Bearer token
  --debug                       Enable debug logging.
  --help                        Show this message and exit.

Synopsis

The apply_chart command will deploy an armada chart definition, installing or updating as appropriate.

armada apply_chart --release-prefix=armada my-chart.yaml [--debug] armada apply_chart --release-prefix=armada kube:armadacharts/my-namespace/my-chart [--debug]